Huawei Quidway S5600 Series Operation Manual page 156

Operation Manual – GVRP
Quidway S5600 Series Ethernet Switches-Release 1510
Operation
Exit and return to
system view
Enable
globally
Enter
port view
Enable GVRP on
the port
Configure GVRP
port registration
mode
The timeout ranges of the timers vary depending on the timeout values you set for other
timers. If you want to set the timeout time of a timer to a value out of the current range,
you can set the timeout time of the associated timer to another value to change the
timeout range of this timer.
The following table describes the relations between the timers:
Table 1-3 Relations between the timers
Timer
Hold
Join
Command
quit
GVRP
gvrp
Ethernet interface
interface-number
gvrp
gvrp registration { fixed |
forbidden | normal }
Lower threshold
10 centiseconds
This lower threshold
greater than or equal to twice
the timeout time of the Hold
timer. You can change the
threshold by changing the
timeout time of the Hold
timer.
Huawei Technologies Proprietary
—
Required
By default, GVRP is disabled
globally.
interface-type
—
Required
By default, GVRP is disabled on
the port.
After you enable GVRP on a
trunk port, you cannot change
the port to a different type.
Optional
You can choose one of the
three modes.
By
registration mode is normal.
Upper threshold
This upper threshold is less than or
equal to one-half of the timeout time
of the Join timer. You can change the
threshold by changing the timeout
time of the Join timer.
is
This upper threshold is less than
one-half of the timeout time of the
Leave timer. You can change the
threshold by changing the timeout
time of the Leave timer.
1-5
Chapter 1 GVRP Configuration
Description
default, GVRP port