Huawei Quidway S5600 Series Operation Manual page 375

Operation Manual – Routing Protocol
Quidway S5600 Series Ethernet Switches-Release 1510
Interval for sending the update packets
MD5 authentication password
5.6.2 Adjusting and Optimizing a BGP Network
Table 5-14 Adjust and optimize a BGP network
Enter system view
Enable BGP, and enter BGP
view
Configure
BGP timer
Configure the interval at which
a peer group sends the same
route update packet
Configure
routes to be received from the
BGP peer/peer group
Operation
Configure the
Keepalive
time and
Holdtime of
BGP.
Configure the
Keepalive
time and
holdtime of a
specified
peer/peer
group.
the number of
Huawei Technologies Proprietary
Command
system-view
bgp as-number
timer keepalive
keepalive-interval
hold
holdtime-interval
peer { group-name |
ip-address } timer
keepalive
keepalive-interval
hold
holdtime-interval
peer group-name
route-update-interv
al seconds
peer { group-name |
ip-address }
route-limit
prefix-number
[ [
alert-only |
reconnect
reconnect-time ] |
percentage-value ]*
5-30
Chapter 5 BGP Configuration
Description
—
Required
By default, BGP
disabled.
Optional
By default, the keepalive
time is 60 seconds, and
holdtime is 180 seconds.
The priority of the timer
configured by the timer
command is lower than
that of the timer
configured by the peer
time command.
Optional
By default, the interval at
which a peer group sends
the same route update
packet to IBGP peers is
15 seconds, and to EBGP
peers is 30 seconds.
Optional
By default, there is no limit
on the number of routes to
be received from the BGP
peer/peer group.
is