Leaf Node Configuration - Huawei Quidway S5600 Series Operation Manual

Operation Manual – MSTP
Quidway S5600 Series Ethernet Switches-Release 1510
Other MSTP-related settings can take effect only after MSTP is enabled on the switch.
II. Configuration example
# Enable MSTP on the switch and disable MSTP on GigabitEthernet1/0/1 port.
Configure in system view.
<Quidway> system-view
[Quidway] stp enable
[Quidway] stp interface GigabitEthernet1/0/1 disable
Configure in Ethernet port view.
<Quidway> system-view
[Quidway] stp enable
[Quidway] interface GigabitEthernet1/0/1
[Quidway-GigabitEthernet1/0/1] stp disable

1.3 Leaf Node Configuration

Table 1-21 lists MSTP-related configurations about leaf nodes.
Table 1-21 Leaf node configuration
Operation
MSTP configuration
MST
configuration
MSTP
mode configuration
Timeout time factor
configuration
Maximum
transmitting
configuration
Edge
configuration
Path
configuration
Port
configuration
Remarks
Required
To prevent
topology jitter caused by
other
configurations,
recommended to enable
MSTP after
other configurations.
region
Required
operation
Optional
Optional
Optional
speed
The
recommended.
port
Optional
cost
Optional
priority
Optional
Huawei Technologies Proprietary
1-25
Chapter 1 MSTP Configuration
network
Section
related
Configuration"
you are
performing
Section 1.2.2 "MST Region
Configuration"
Section
Operation
Configuration"
Section 1.2.10
Time Factor Configuration"
Section 1.2.11
Transmitting
default is
Configuration"
Section 1.2.12
Configuration"
Section 1.3.7
Configuration"
Section 1.3.8 "Port Priority
Configuration"
Related section
1.2.14 "MSTP
1.2.6 "MSTP
Mode
"Timeout
"Maximum
Speed
"Edge Port
"Path Cost