Vlan-Vpn Configuration; Configuration Prerequisites; Configuration Procedure - Huawei Quidway S5600 Series Operation Manual

Operation Manual – VLAN VPN
Quidway S5600 Series Ethernet Switches-Release 1510
packet. Otherwise, the packet becomes a packet carrying the default VLAN tag of the
port.

1.2 VLAN-VPN Configuration

1.2.1 Configuration Prerequisites

GARP VLAN registration protocol (GVRP), GARP multicast registration protocol
(GMRP), neighbor topology discovery protocol (NTDP), spanning tree protocol
(STP) , 802.1x protocol,and Centralized MAC address authentication are disabled
on the port.
The port is must an access port.
Caution:
If any of the protocols among GVRP, GMRP, NTDP, STP, 802.1x, and Centralized
MAC address authentication is enabled for a port, you can not enable the
VLAN-VPN function for the port.
By default, STP and NTDP are enabled on a device. You can disable these two
protocols using the stp disable and undo ntdp enable commands.

1.2.2 Configuration procedure

Table 1-1 Configure the VLAN-VPN function for a port
Operation
Enter system view
Enter Ethernet port
view
Enable
VLAN-VPN
function on the port
Display VLAN VPN
configuration
information about
all ports
Command
system-view
interface interface-type
interface-number
the
vlan-vpn enable
display port vlan-vpn
Huawei Technologies Proprietary
1-2
Chapter 1 VLAN-VPN Configuration
Description
—
—
Required
By default, the VLAN-VPN
function is disabled on a port.
You can execute the display
command in any view.