Setting The Poe Mode On A Port; Configuring The Pd Compatibility Detection Feature - Huawei Quidway S5600 Series Operation Manual

Operation Manual – PoE & PoE Profile
Quidway S5600 Series Ethernet Switches-Release 1510
Enter Ethernet port view
Se the PoE priority of a
port

1.6 Setting the PoE Mode on a Port

After the PoE feature is enabled on the port, perform the following configuration to set
the PoE mode on a port.
Table 1-5 Set the PoE mode on a port
Enter system view
Enter Ethernet port view
Set the PoE mode on the port

1.7 Configuring the PD Compatibility Detection Feature

After the PD compatibility detection feature is enabled, the switch can supply power to
the detected PDs that do not conform to the 802.3af standard.
After the PoE feature is enabled, perform the following configuration to enable the PD
compatibility detection feature.
Table 1-6 Configure the PD compatibility detection feature
Enter system view
Enable the PD compatibility
detection function
Operation
interface
interface-number
poe priority { critical |
high | low }
Operation
Operation
Huawei Technologies Proprietary
Command
interface-type
Command
system-view
interface
interface-type
interface-number
poe mode { signal |
spare }
Command
system-view
poe legacy enable
1-5
Chapter 1 PoE Configuration
Description
—
Required
By default, the PoE
priority of a port is
low
Description
—
—
Required
S5600 series
Ethernet
switches do not
support PoE in
the spare mode
currently
Description
—
Required
By default, the
PD compatibility
detection feature
is disabled