Huawei Quidway S5600 Series Operation Manual page 898

Operation Manual – FTP and TFTP
Quidway S5600 Series Ethernet Switches-Release 1510
Note:
The specified interface must be an existing one, and otherwise a prompt appears
to show the configuration fails.
The value of argument ip-address must be an IP address on the device where the
configuration is performed, and otherwise a prompt appears to show the
configuration fails.
You may specify only one source interface or source IP address for the FTP at one
time. That is, only one of the commands source-interface and ftp-server
source-ip can be valid at one time. If you execute both of them, the new setting
will overwrite the original one.
IV. Disconnecting a specified user
On the FTP server, you can disconnect a specified user from the FTP server to secure
the network.
Table 1-5 Disconnect a specified user
Enter system view
On the
disconnect
user from the FTP server
Note:
If you attempt to disconnect a user that is uploading/downloading data to/from the
FTP server that is acted by an S5600, the S5600 will disconnect the user after the
data transmission is completed.
V. Displaying FTP server information
After the above configurations, you can run the display command in any view to
display the running information of the FTP server and verify your configurations.
Table 1-6 Display FTP server information
Display the information
about
configurations on a switch
Operation
system-view
FTP server,
a specified
ftp disconnect user-name
Operation
FTP server
display ftp-server
Huawei Technologies Proprietary
Chapter 1 FTP and TFTP Configuration
Command
Command
1-5
Description
—
Required
Description
These commands can be
executed in any view.