Huawei Quidway S5600 Series Operation Manual page 303

Operation Manual – Routing Protocol
Quidway S5600 Series Ethernet Switches-Release 1510
3.3.2 Configuring Basic RIP Functions
I. Enabling RIP globally and on the interface of a specified network segment
Table 3-2 Enable RIP globally and on the interface of a specified network segment
Operation
Enter system view
Enable RIP globally and
enter RIP view
Enable
interface of a specified
network segment
Note:
RIP can be enabled on an interface only after it has been enabled globally.
RIP operates on the interface of a network segment only when it is enabled on the
interface. When RIP is disabled on an interface, it does not operate on the interface,
that is, it neither receives/sends routes on the interface nor forwards its interface
route. Therefore, after RIP is enabled globally, you must also specify its operating
network segments to enable it on the corresponding interfaces.
The network 0.0.0.0 command is used to enable RIP on all interfaces.
II. Setting the RIP operating status on an interface
Table 3-3 Setting the RIP operating status on an interface
Operation
Enter system view
Enter interface view
Enable the interface to
receive
packets
Enable the interface to
send
packets
Run RIP
interface
system-view
rip
RIP on the
network
network-address
system-view
interface
interface-number
RIP update
rip input
RIP update rip output
on the
rip work
Huawei Technologies Proprietary
Command
Command
interface-type
3-4
Chapter 3 RIP Configuration
Description
—
—
Required
By default, RIP is disabled
on any interface.
Description
—
—
Optional
By default, except for
loopback interface, all
interfaces are allowed
to send and receive
RIP packets.