Huawei Quidway S5600 Series Operation Manual page 357

Hide thumbs Also See for Quidway S5600 Series:
Table of Contents

Advertisement

Operation Manual – Routing Protocol
Quidway S5600 Series Ethernet Switches-Release 1510
A large-scale network can contain large amount of peers, lot of which adopt the same
policies. Peer group simplifies your configuration when you configure peers adopting
the same policy.
As the peers in a peer group adopt the same route updating policy, peer group gains
more efficiency in route advertising.
Caution:
If a BGP peer and the peer group containing the BGP peer are configured differently,
the last configuration takes effect.
IV. Community
Different form peer group, you can apply the same policy to BGP routers residing in
different ASs through community. Community is a route attribute transmitted among
BGP peers. It is independent of AS.
Before sending a route with the community attribute to its peers, a BGP router can
change the original community attribute of the route.
Besides the well-known community attributes, you can also use the community
attributes list to customize extended community attributes, so as to control the routing
policy with more flexibility.
V. Router reflector
To ensure the connectivity among the IBGP peers in an AS, you need to make the IBGP
peers fully connected. For an AS with the number of the routers in it being n, you need
to establish at least n*(n-1)/2 IBGP connections to make them fully connected. This
requires large amount of network resources and CPU time if large amount of IBGP
peers exist in the AS.
You can decrease the use of network resources and CPU time through route reflection
in this case. That is, use a router as a router reflector (RR) and establish IBGP
connections between the RR and other routers known as clients. Routing information
exchanged between the clients is passed/reflected by the RR. This eliminates the need
to establish IBGP connections among the clients.
Note that a BGP router which is neither the RR nor a client is called a non-client.
Non-clients and the RR must be fully connected, as shown in Figure 5-10.
Huawei Technologies Proprietary
5-12
Chapter 5 BGP Configuration

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents