Telnet Configuration With Authentication Mode Being Password - Huawei Quidway S5600 Series Operation Manual

Operation Manual – Login
Quidway S5600 Series Ethernet Switches-Release 1510
<Quidway> system-view
# Enter VTY 0 user interface view.
[Quidway] user-interface vty 0
# Configure not to authenticate Telnet users logging into VTY 0.
[Quidway-ui-vty0] authentication-mode none
# Specify commands of level 2 are available to users logging into VTY 0.
[Quidway-ui-vty0] user privilege level 2
# Configure Telnet protocol is supported.
[Quidway-ui-vty0] protocol inbound telnet
# Set the maximum number of lines the screen can contain to 30.
[Quidway-ui-vty0] screen-length 30
# Set the maximum number of commands the history command buffer can store to 20.
[Quidway-ui-vty0] history-command max-size 20
# Set the timeout time to 6 minutes.
[Quidway-ui-vty0] idle-timeout 6
3.3 Telnet Configuration with Authentication Mode Being
Password
3.3.1 Configuration Procedure
Table 3-6 Telnet configuration with the authentication mode being password
Operation
Enter system view
Enter one or more
VTY user interface
views
Configure
authenticate users
logging into VTY
user
using
password
Set the
password
system-view
user-interface
first-number [ last-number ]
to
authentication-mode
interfaces password
the local
set
local
password
simple } password
Huawei Technologies Proprietary
Chapter 3 Logging in through Telnet
Command
vty
authentication
{ cipher |
3-6
Description
—
—
Required
Required