Enabling Information Output To A Log Host - Huawei Quidway S5600 Series Operation Manual

Operation Manual – Information Center
Quidway S5600 Series Ethernet Switches-Release 1510
Note:
Running the info-center synchronous command during debugging information
collection may result in a command prompt echoed after each item of debugging
information. To avoid unnecessary output, it is recommended that you disable
synchronous terminal output in such cases.

1.2.2 Enabling Information Output to a Log Host

Table 1-5 lists the related configurations on the switch.
Table 1-5 Enable information output to a log host
Operation
Enter system view
Enable
information center
Enable information
output
specified switch in
a fabric
Enable information
output to a log host
Configure
source
through which log
information is sent
to the log host
Command
system-view
the
info-center enable
info-center
for a { unit unit-id | master | all }
[ debugging | logging |
trapping ]*
info-center
host-ip-addr
{ channel-number
channel-name } | facility
local-number
{ chinese | english } ]*
the
interface info-center loghost source
interface-type
interface-number
Huawei Technologies Proprietary
—
Optional
By default, the information
center is enabled.
By
information output is enabled ,
and log and trap information
switch-on
output are disabled for the
master switch in a fabric.
Debugging,
information output are all
disabled for other switches in
the fabric.
Required
By default, the switch does
not output information to the
log host.
loghost
After you configure the switch
[ channel
to output information to the log
|
host,
information
| language
default.
Be sure to set the correct IP
address.
address will cause an error
message prompting invalid
address.
Optional
1-7
Chapter 1 Information Center
Description
default, debugging
log and
the switch uses
channel 2
A loopback
trap
by
IP