Huawei Quidway S5600 Series Operation Manual page 645

Operation Manual - DHCP
Quidway S5600 Series Ethernet Switches-Release 1510
Configuration task
Configure
between the DHCP interface
address pool and the BIMS
server
2.3.2 Enabling DHCP
You need to enable DHCP before performing DHCP configurations. DHCP-related
configurations are valid only when DHCP is enabled.
Table 2-12 Enable DHCP
Operation
Enter system view
Enable DHCP
2.3.3 Configuring to Assign the IP Addresses of Interface Address Pools to
DHCP Clients
If the DHCP server works in the interface address pool mode, it picks IP addresses
from the interface address pools and assigns them to the DHCP clients. If there is no
available IP address in the interface address pools, the DHCP server picks IP
addresses from its global address pool that contains the interface address pool
segment and assigns them to the DHCP clients.
Table 2-13 Configure to assign the IP addresses of interface address pools to DHCP
clients
Enter system view
Configure
assign the IP
addresses
interface
address
the connection
Command
system-view
dhcp enable
Operation
to
Configure
of
the current
interface
pools
Huawei Technologies Proprietary
Chapter 2 DHCP Server Configuration
Remarks
Optional
—
Required
By default, DHCP is enabled
Command
system-view
interface interface-type
interface-number
dhcp select interface
quit
2-15
Section
2.3.8 "Configure
Connection Between the
DHCP Interface Address
Pool and the BIMS
Server"
Description
Description
—
Required
By default, a DHCP
server assigns the
IP addresses of the
global address pool