Huawei Quidway S5600 Series Operation Manual page 244

Operation Manual – MSTP
Quidway S5600 Series Ethernet Switches-Release 1510
Operation
Maximum hops of
MST
configuration
Network
configuration
MSTP time-related
configuration
Timeout time factor
configuration
Maximum
transmitting speed
configuration
Edge
configuration
Point-to-point
related
configuration
Note:
In a network that contains switches with both GVRP and MSTP employed, GVRP
packets are forwarded along the CIST. If you want to broadcast packets of a specific
VLAN through GVRP, be sure to map the VLAN to the CIST when configuring the
MSTP VLAN mapping table (The CIST of a network is the spanning tree instance
numbered 0.)
1.2.1 Prerequisites
The status of the switches in the spanning trees are determined. That is, the status
(root, branch, or leaf) of each switch in each spanning tree instance is determined.
1.2.2 MST Region Configuration
I. Configuration procedure
Table 1-3 Configure an MST region
Operation
Enter system view
region Optional
Optional
diameter
The default is recommended.
Optional
The
recommended.
Optional
Optional
The default is recommended.
port
Optional
link
Optional
Command
system-view
Huawei Technologies Proprietary
Remarks
defaults are
—
1-8
Chapter 1 MSTP Configuration
Related section
Section 1.2.7 "MST
Region Maximum Hops
Configuration"
Section 1.2.8 "Network
Diameter Configuration"
Section 1.2.9 "MSTP
Time-related
Configuration"
Section 1.2.10 "Timeout
Time Factor Configuration"
Section 1.2.11 "Maximum
Transmitting Speed
Configuration"
Section 1.2.12 "Edge Port
Configuration"
Section 1.2.13
Point-to-point Link-Related
Configuration"
Description