Loop Prevention Configuration - Huawei Quidway S5600 Series Operation Manual

Operation Manual – MSTP
Quidway S5600 Series Ethernet Switches-Release 1510
Table 1-32 Enable the root protection function in Ethernet port view
Operation
Enter system view
Enter Ethernet port
view
Enable
protection function
on current port
II. Configuration example
# Enable the root protection function on GigabitEthernet1/0/1 port.
Configure in system view.
<Quidway> system-view
[Quidway] stp interface GigabitEthernet1/0/1 root-protection
Configure in Ethernet port view.
<Quidway> system-view
[Quidway] interface GigabitEthernet1/0/1
[Quidway-GigabitEthernet1/0/1] stp root-protection

1.5.5 Loop Prevention Configuration

I. Configuration Procedure
Table 1-33 Enable the loop prevention function on a port
Operation
Enter system view
Enter Ethernet port
view
Enable
prevention function
on the current port
II. Configuration example
# Enable loop prevention function on GigabitEthernet1/0/1 port.
<Quidway> system-view
[Quidway] interface GigabitEthernet1/0/1
[Quidway-GigabitEthernet1/0/1] stp loop-protection
Command
system-view
Interface
interface-number
the root
stp root-protection
Command
system-view
interface
interface-number
the loop
stp loop-protection
Huawei Technologies Proprietary
—
interface-type
—
Required
The root protection function is
disabled by default.
—
interface-type
—
Required
The loop prevention function
is disabled by default.
1-35
Chapter 1 MSTP Configuration
Description
Description