Displaying And Debugging Ntp - Huawei Quidway S5600 Series Operation Manual

Operation Manual – NTP
Quidway S5600 Series Ethernet Switches-Release 1510
Operation
Configure
number
sessions that can
be
locally
Enter
interface view
Disable
interface
receiving
packets
Caution:
The source IP address in an NTP packet is the address of the sending interface
specified by the ntp-service unicast-server command or the ntp-service
unicast-peer command if you provide the address of the sending interface in
these two commands.
Dynamic connections can only be established when a switch operates in passive
peer mode, NTP broadcast client mode, or NTP multicast client mode. In other
modes, the connections established are static.

1.6 Displaying and Debugging NTP

After the above configuration, you can execute the display command in any view to
display the running status of the NTP configuration, and verify the effect of the
configuration.
Table 1-7 Display and debug NTP
Display the status of NTP service
Display the information about the
sessions maintained by NTP
Display the brief information about
the NTP
reference clock sources that the
local device traces to
the
of the ntp-service
max-dynamic-sessions
established
number
VLAN interface
vlan-id
the
from ntp-service
NTP disable
Operation
time servers of
Huawei Technologies Proprietary
Command
Vlan-interface
in-interface
Command
display
status
display
sessions [ verbose ]
the display
trace
1-13
Chapter 1 NTP Configuration
Description
Optional
By default, up to 100 dynamic
sessions can be established
locally.
—
Optional
By default, a VLAN interface
receives NTP packets.
Description
ntp-service
The
ntp-service
command can
be executed in
any view
ntp-service
display