Huawei Quidway S5600 Series Operation Manual page 753

Operation Manual – Mirroring
Quidway S5600 Series Ethernet Switches-Release 1510
Operation
Configure the source
port and specify the
direction
packets to be mirrored
Display
settings
mirroring
Note:
Configurations listed in Table 1-5 do not involve specifying a mirroring group.
Therefore these mirroring settings made in Ethernet port view applies to mirroring
group 1 only.
Configurations listed in Table 1-6 can be used to add mirroring settings for any
defined mirroring group in Ethernet port view.
Configurations listed in Table 1-7 should to be performed in system view. Therefore
the mirroring group ID and port number need to be specified.
IV. Configuration Example
The source port is GigabitEthernet 1/0/1. Mirror all packets received and sent via
this port.
The destination port is GigabitEthernet 1/0/4.
1) Configuration procedure 1:
<Quidway> system-view
[Quidway] mirroring-group 1 local
[Quidway] interface gigabitEthernet 1/0/4
[Quidway-GigabitEthernet1/0/4] monitor-port
[Quidway-GigabitEthernet1/0/4] quit
[Quidway] interface gigabitEthernet 1/0/1
[Quidway-GigabitEthernet1/0/1] mirroring-port both
2) Configuration procedure 2:
<Quidway> system-view
[Quidway] mirroring-group 1 local
[Quidway] interface GigabitEthernet 1/0/4
[Quidway-GigabitEthernet1/0/4] mirroring-group 1 monitor-port
[Quidway-GigabitEthernet1/0/4] quit
[Quidway] interface GigabitEthernet 1/0/1
[Quidway-GigabitEthernet1/0/1] mirroring-group 1 mirroring-port both
3) Configuration procedure 3:
<Quidway> system-view
mirroring-group
mirroring-port
of the mirroring-port-list
inbound | outbound }
parameter
display mirroring-group { all |
of the
local }
Huawei Technologies Proprietary
1-8
Chapter 1 Mirroring Configuration
Command
group-id
{ both |
Description
Required
Optional
This command can be
executed in any view.