Setting The Outputs - Omron FQ2-S/CH Series User Manual

Setting the Outputs

Using the Overall Judgement Result
When the results of the inspection items are judged, if even one individual judgement result is NG, the OR
output signal is turned ON.
Note
• The overall judgement result output signal can also be turned ON when all individual judgement results are OK.
Changing the judgement output ON condition: p. 44
• You can select whether to include the judgement result of one of the expressions (0 through 31) in the overall judge-
ment.
Section 4 Setting Up Inspections
in Sensor FQ2-S/CH Series User's Manual (Cat. No. Z337)
• You can adjust the timing for outputting the OR signal and the ON time after judgement processing.
Adjust the Judgement Output Timing: p. 42
Wiring
Color Signal
Black OUT0 (OR)
Timing Chart
The OR signal that is output is held until the next overall judgement is output.
ON
TRIG signal
OFF
ON
BUSY signal
OFF
OR signal
40
Controlling Operation and Outputting Data with the Sensor's Standard Parallel Connection
Individual judgement results
Inspection
OK
item 0
NG
Inspection
item 1
Inspection
OK
item 31
Expression
OK
Description
Overall judgement (default
assignment)
ON for 1 ms min.
ON while measurements are
being processed (depends
on BUSY output conditions)
Overall judgement
NG (OR signal ON)
If there is even one NG judgement,
the overall judgement will be NG
and the output will be turned ON.
The signals shown at the left are used.
Refer to the following information for signal wiring.
Section 2 Installation and Connections
in Sensor FQ2-S/CH Series User's Manual
(Cat. No. Z337)
Overall judgement
Turned ON when overall
judgement is NG.
(OR output: ON for NG)
FQ2-S/CH User's Manual
for Communications Settings