Setting The Data To Output Automatically After Measurements - Omron FQ2-S/CH Series User Manual

Setting the Data to Output Automatically after Measurements

You can set in advance the data to output automatically after measurements. (You can set up to 32 data items.)
Data That Can Be Output
• Data Output
On the FQ2, data that is output after measurement can be assigned to Data 0 to Data 31 in the output data
settings.
When an item is assigned to an output data setting, the data is output in units of four bytes per item.
The maximum data size that can be output at once is 1,024 bytes.
Note
If multiple inspection results are assigned to one output data setting, that output data setting will be set for more than
four bytes of data output. As a result, it is possible that an item that exceeds the data size that can be output at once
will be set in the data output setting. In this case, the data that exceeds the data size will be discarded.
Output Order of Measurement Data and Output Characters: p.26
The measurement data from inspection items that can be output and the calculation results from the
expression settings can be output. For data that can be output, refer to the Measurement Data That Can Be
Used for External Outputs and Calculations for each inspection item.
Assigning Detection Results to Output Data: p. 128
Assigning More Than One Detection Result to Output Data: p. 129
• Outputting Character Strings (Only Supported on the FQ2-S4/CH)
You can output a character string for each of the inspection items that reads a character string, such as the
OCR inspection item. Also, when reading the character string fails, you can output a specific character string
that is set in advance.
Outputting Read Character Strings: p. 131
FQ2-S/CH User's Manual
for Communications Settings
Controlling Operation and Outputting Data with PLC Link Communications
127