Omron FQ2-S/CH Series User Manual page 447


Save Calibration Data
This command saves the calibration data with the specified calibration number as a file to the SD card inserted
in the Touch Finder.
The destination for calibration data is the following fixed directory on the SD card.
\Sensor name\CLB
Format
MRC SRC Sensor command code (4
(1 byte) (1 byte) bytes)
28 0F 0070A000
Response Format
MRC SRC MRES
(1 byte) (1 byte) (1 byte)
28 0F End code
End Codes
End code (hex) Description
0000 Command execution ended normally.
FFFF Command execution ended in an error.
Parameter Descriptions
Calibration number Specifies the scene number (0 to 31) to be saved.
Calibration data file Specifies the file name when saving.
name The file name extension (.clb) can be omitted.
Important
• If the specified file name already exists, this existing file will be overwritten.
• Do not turn off power to the Sensor until there is a response.
FQ2-S/CH User's Manual
for Communications Settings
Calibration
number to save
(4 bytes)
2 digits max.
SRES Sensor command code (4 bytes)
(1 byte)
0070A000
Calibration data
file name
(4 to 64 bytes)
64 characters
max.
445
Command Control