Omron FQ2-S/CH Series User Manual page 345

PARAALLCOND or PAC
Batch Set Terminal Statuses
Batch sets the ON/OFF status for the all parallel I/O output terminals other than the D terminals (D0 to D15).
Important
• Before executing this command, change the FQ2 execution mode to stop mode with the Set Execution Mode com-
mand.
• If the FQ2 is not in stop mode, some parallel terminals cannot be turned ON or OFF with this command.
Set Execution Mode p.267
<Command Format>
Command
P A R A A L
or
P A C
Command Terminal status
(5 digits max.)
Space
(0x20)
<Response Format>
When the Command Is Processed Normally
O K CR
Delimiter
When the Command Is Not Processed Normally
E R CR
Delimiter
FQ2-S/CH User's Manual
for Communications Settings
L C O N D
Space
(0x20)
CR
Delimiter
Terminal status
(5 digits max.)
CR
Delimiter
343
Command Control