Omron FQ2-S/CH Series User Manual page 253

Smart camera

Hide thumbs Also See for FQ2-S/CH Series:

Table of Contents

Set Terminal Offset Data

This command sets the value of the terminal offset data that is added to the IN0 to IN4 command parameters

when executing parallel commands.

When using parallel command scene changing, you can change the scenes to change to by changing the Set

Terminal Offset Data value.

Command (PLC to Sensor)

First word of com-

Response (Sensor to PLC)

First word of

response area

FQ2-S/CH User's Manual

for Communications Settings

Command code

Terminal offset value

Value added to the IN0 to IN4 command

parameters when executing parallel com-

Command code

The command code for which the response

applies is stored.

Response code

Command execution result

0: OK, FFFFFFFF: NG

Command Control

Chapters

Table of Contents