SYSLOAD
This command loads system data that is stored on the SD card inserted in the Touch Finder.
The source for system data is the following fixed directory on the SD card.
\Sensor name\SYD
Note
All output signals are turned OFF after command is executed.
All output signals except RUN signal are turned OFF when Sensor Data Unit is connected.
<Command format>
S Y S L O A D
Space (0x20)
<Response format>
When Processing Is Performed Normally
When Processing Is Not Performed Normally
<Parameter Descriptions>
File name of system data Specifies the system data file name to be loaded.
Important
Do not turn off power to the Sensor until there is a response.
FQ2-S/CH User's Manual
for Communications Settings
C
R
File name of system data
The extension (.syd) can be omitted.
351
Command Control