Setting Up Ethernet/Ip Communications - Omron FQ2-S/CH Series User Manual

Setting Up EtherNet/IP Communications

Setting Network Settings in the Sensor
Set the IP address of the Sensor according to the network where the external devices, such as PLCs, are
connected.
(Setup Mode) − [Sensor settings] − [Network] − [Ethernet] − [IP address setting]
1
Press [Fixed].
2
Set the IP address and subnet mask according to the network where the external devices, such
as PLCs, are connected.
Note
If you connect OMRON CS/CJ-series PLCs to the Ethernet, the following default IP addresses are assigned to the
PLCs.
• IP address: 192.168.250.node_address
Important
To use EtherNet/IP communications, do not automatically assign an IP address to the Sensor. Set a specific IP
address and do not change it.
Initial Settings for EtherNet/IP Communications
(Setup Mode) − [Sensor settings] − [Data output] − [Link data output]
1
Press [Communication type].
2
Press [EtherNet/IP].
3
Set the EtherNet/IP communications parameters as
described in the following table.
92
Controlling Operation and Outputting Data with EtherNet/IP Communications
[Output handshake] Set to [Yes]
[Output handshake] Set to [No]
FQ2-S/CH User's Manual
for Communications Settings