Omron FQ2-S/CH Series User Manual page 113

Important
After you execute the Reset command (0010F010 hex) for the Sensor, turn OFF the EXE signal before the Sensor
restarts. If you leave the EXE signal ON, the Sensor will restart repeatedly.
 Commands to Get Status
Command code in
command area (hex)
+2 +3
1000 0020 Get Scene Number
 Commands to Set Status
Command code in
command area (hex)
+2 +3
1000 0030 Select Scene
 Commands to Read Data
Command code in
command area (hex)
+2 +3
1010 0040 Get Image Adjustment Item
Data
1020 0040 Get Inspection Item Data
1040 0040 Acquire Camera Parameter
2000 0040 Acquire Date and Time Infor-
mation
3000 0040 Get Software Version Informa-
tion
4010 0040 Acquire System Data
4060 0040 Acquire Terminal Offset Data
6010 0040 Acquire Statistical Data
FQ2-S/CH User's Manual
for Communications Settings
Command name
Acquires the scene number currently being
used.
Command name
Changes the scene number to be used.
Command name
Acquires parameters and measurement val-
ues for a position compensation item or filter
item.
Acquires parameters and measurement val-
ues for the specified inspection item.
Acquires the value of the specified camera
parameter.
Acquires the current date and time informa-
tion.
Acquires the Sensor's software version.
Acquires the value set for the specified sys-
tem data.
Acquires the terminal offset data that is
added to the IN0 to IN4 command parame-
ters when executing parallel commands.
Acquires the statistical data (such as the
number of measurements, number of NG
overall judgments, and other information,
since the power supply was turned ON) held
by the Sensor.
Controlling Operation and Outputting Data with EtherNet/IP Communications
Function
Function
Function
Reference
p.226
Reference
p.226
Reference
p.227
p.228
p.229
p.246
p.232
p.233
p.237
p.238
111