Omron FQ2-S/CH Series User Manual page 66

[In/Out] − [I/O setting] − [Output data set] − [Parallel Data Output Setting] − [Details] Tab Page −
[Output parameter] − [Data output]
 Output Specifications
• Only the integer portions of numbers are output. All digits before the decimal point are rounded off.
• The following range of values can be output.
Binary data: −32768 to +32767
BCD data: −999 to +999
If the measurement value is out of range, the actual measurement value is not output and the minimum or
maximum value of the range is output instead.
Data format
Binary data
BCD
Note
The data that is output to the OR and D signals after a measurement is held until the next measurement is per-
formed. The values will continue to be output even after all measurements have been completed.
However, if you set the output timing of the OR signal to [One-shot output] in the [Output mode] parameter, the OR
signal will turn OFF after the specified output time has elapsed.
Data Output Timing
 Output Sequence
If both parallel judgement output and parallel data output are performed at the same time, parallel judgement
output will be performed first followed by parallel data output.
Example: Parallel Judgement Output of D0 to D15 and Parallel Data Output of Data 0
64
Controlling Operation and Outputting Data with a Parallel Interface Sensor Data Unit
Measurement value that is below the possi-
ble output range
A value of −32768 is output.
A value of −999 is output.
D0
D1
D15
Measurement value that is above the possi-
ble output range
A value of +32767 is output.
A value of 999 is output.
Parallel judgement Parallel data output
output D0 (data 0)
Parallel judgement Parallel data output
output D1 (data 0)
Parallel judgement Parallel data output
output D15 (data 0)
FQ2-S/CH User's Manual
for Communications Settings