Omron FQ2-S/CH Series User Manual page 441

Save Configuration Data Commands

Save Scene Data
This command saves scene data to the SD card inserted in the Touch Finder as a file.
The destination for scene data is the following fixed directory on the SD card.
\Sensor name\SCN
Format
MRC SRC Sensor command code (4
(1 byte) (1 byte) bytes)
28 0F 00701000
Response Format
MRC SRC MRES
(1 byte) (1 byte) (1 byte)
28 0F End code
End Codes
End code (hex)
0000 Command execution ended normally.
FFFF Command execution ended in an error.
Parameter Descriptions
Scene number Specifies the scene number (0 to 31) to be saved.
Scene data file name Specifies the file name when saving.
The file name extension (.scn) can be omitted.
Important
• If the specified file name already exists, this existing file will be overwritten.
• Do not turn off power to the Sensor until there is a response.
FQ2-S/CH User's Manual
for Communications Settings
Save scene number (4 bytes)
2 digits max.
SRES Sensor command code
(1 byte) (4 bytes)
00701000
Description
Scene data file name
(4 to 64 bytes)
64 characters max.
Command Control
439