Omron FQ2-S/CH Series User Manual page 17

Note
Connections Across Network Routers
You can connect to a Sensor on a different network than the Touch Finder or PC Tool through a router.
• To connect to a Sensor, directly specify the IP address of the Sensor. Automatic connection to a Sensor is not
possible.
• Use a fixed IP address for the Sensor to connect to.
Models That Are Compatible with the Communications Protocols
This section lists the external devices that can communicate with the FQ2-S/CH series for each
communications protocol.
PLC Link
OMRON
Series
SYSMAC NJ NJ-501 or NJ-301
SYSMAC_CJ2 CJ2H or CJ2M
CJ1H or CJ1G
SYSMAC_CJ1
CJ1M
SYSMAC_CS CS1H, CS1D, or CS1G
CP1L
SYSMAC_CP1
CP1H
SYSMAC_One NSJ
FQ2-S/CH User's Manual
for Communications Settings
: Can connect : Only some models can connect : Cannot connect
Direct connection with CPU unit
CPU Unit
(built-in port)
(Built-in port only.)
(Built-in port only.)
(Built-in port only.)
Interface
Connection via Ethernet unit

CJ1W-EIP21(V2.1or later)
Needs the NJ series version1.01
or later.

CJ1W-EIP21 (PLC Link only)
CJ1W-ETN21

CJ1W-EIP21 (PLC Link only)
CJ1W-ETN21

CJ1W-EIP21 (PLC Link only)
CJ1W-ETN21

CS1W-EIP21 (PLC Link only)
CS1W-ETN21


CJ1W-EIP21 (PLC Link only)
CJ1W-ETN21

NSJW-ETN21
Communicating with an External Device
---
15