Omron FQ2-S/CH Series User Manual page 237

System Type Item
data num-
ber
114 Parallel OUT1 signal
control assignment
115 Parallel OUT2 signal
control assignment
116 Parallel Input mode
control
117 Parallel LED BUSY
control
3 Retry func- Retry mode
tion
4 Retry func- Switch order
tion (scene switch-
ing)
5 Retry func- Switch order
tion (target scene)
6 Retry func- Timeout time
tion
201 Parallel OR output
Interface
Sensor
Data Unit
202 Parallel Judgment out-
Interface put mode
Sensor
Data Unit
203 Parallel OR output
Interface delay time
Sensor
Data Unit
FQ2-S/CH User's Manual
for Communications Settings
Data Range
size
4 0: Control signal
1 to 32: OR0 to 31
1001 to 1032: Expression 1 to 32
2001: OR (overall judgement)
2002: BUSY
2003: ERROR
2004: READY
2005: RUN
2006: STG
4 0: Control signal
1 to 32: OR0 to 31
1001 to 1032: Expression 1 to 32
2001: OR (overall judgement)
2002: BUSY
2003: ERROR
2004: READY
2005: RUN
2006: STG
4 0: Standard mode (scene chang-
ing only)
1: Expanded mode
4 0: BUSY
1: RUN
4 0: None
1: Normal retry
2: Exposure retry
3: Scene retry
4: Trigger retry
4 0: Auto
1: Fixed
4 -1: none (termination)
0 to 31: Target scene number
4 100 to 9,999 (msec)
4 0: OK: ON
1: NG: ON
4 0: Level output
1: One-shot output
4 0 to 10,000
Description
Specifies whether to use
the signal as a control sig-
nal or to use the signal as a
judgment output (OR indi-
vidual output signal) for
inspection items.
Specifies whether to use
the signal as a control sig-
nal or to use the signal as a
judgment output (OR indi-
vidual output signal) for
inspection items.
Specifies whether or not to
enable functions other than
scene changing with exter-
nal parallel commands.
Specifies whether to syn-
chronize the BUSY indica-
tor with BUSY or with RUN.
Specifies the retry mode.
Specifies the scene switch-
ing order for scene chang-
ing retries.
Specifies the target scene
number of the scene
switching
Scene retry timeout time
Specifies the polarity when
the OUT0 output signal is
ON. Overall judgements
are supported.
Specifies whether output is
one-shot output or level
output.
Specifies the ON delay
time (x0.1 ms) until output-
ting the signal.
Command Control
235