Omron FQ2-S/CH Series User Manual page 415


Set Terminal Status
This command sets the output signal ON/OFF status for the specified parallel I/O terminal.
Note
When turning the parallel terminals ON or OFF with this command, there are terminals that cannot be controlled if
the FQ2 execution mode is not set to stop mode.
In this case, first change the FQ2 execution mode to stop mode with the Set Execution Mode command, and then
execute this command.
Set Execution Mode: p.417
Command Format
MRC SRC Sensor command code (4
(1 byte) (1 byte) bytes)
28 0F 00308010
Response Format
MRC SRC MRES
(1 byte) (1 byte) (1 byte)
28 0F End code
End Codes
End code (hex)
0000 Command execution ended normally.
FFFF Command execution ended in an error.
FQ2-S/CH User's Manual
for Communications Settings
Terminal type (4 bytes)
2 digits max.
SRES Sensor command code (4 bytes)
(1 byte)
00308010
Description
Terminal number Terminal status
(4 bytes) (4 bytes)
1 digit max. 1 digit max.
Command Control
413