Omron FQ2-S/CH Series User Manual page 305

<Parameter Descriptions>
Inspection item number
Region number
Figure number
Parameter 1 to parame-
ter 21
*1 Depending on each inspection item type, the model registration region or measurement region is specified by the following values.
Inspection item types
OCR
Bar Code
2D-code
2D-code (DPM)
Search
Shape Search III
Shape Search II
Sensitive Search
Edge Position
Edge Width
Edge Pitch
Color Data
Area
Labeling
FQ2-S/CH User's Manual
for Communications Settings
Specifies the inspection item number. (0 to 31)
Selects either a measurement region or a model registration region. The value that spec-
ifies each region differs according to the inspection item type.
The measurement region or model registration region range registers a complicated
model or a measurement region by combining a maximum of 8 figures (rectangles, cir-
cles, and other shapes).
With this command, specify the figure number of the figure with the parameters you want
to acquire out of the multiple figures.
The items of information for the figure set as the measurement region or the model regis-
tration region are split up and returned in parameter 1 through parameter 21.
Region number
0 (measurement region)
0 (measurement region)
0 (measurement region)
0 (measurement region)
0 (model registration region)
1 (measurement region)
0 (model registration region)
1 (measurement region)
0 (model registration region)
1 (measurement region)
0 (model registration region)
1 (measurement region)
0 (measurement region)
0 (measurement region)
0 (measurement region)
0 (measurement region)
0 (measurement region)
0 (measurement region)
Command arguments
Figure number
0
0
0
0
0 to 7
0
0 to 7
0
0 to 7
0
0 to 7
0
0
0
0
0 to 7
0 to 7
0 to 7
*1
*2
Command Control
303