Memory Assignments And Commands - Omron FQ2-S/CH Series User Manual

Parameter
NG String output on/off
Note
• Endian
Little endian data is output.
• Code Conversion
The converted codes are outputted for the following character codes.
Before conversion After conversion
Character code
CR &h0D
LF &h0A
DEL
&h7F
FF &hFF

Memory Assignments and Commands

Memory Assignments
This section explains the assignments in the Output Area of the CR for input to the sensor (command area),
the Input Area of the CR for output to external devices (response area), and the Input Area (output area).
Address notation Output Area of the following (command area) is in terms of the representation of the 8-bit units.
Also, please note the appendix command for more information, so we are written in 16-bit units.
CR for Input to Sensor (External Devices (IO Controller) to Sensor (IO Device))
• Output Area (Command Area)
Output Area
(command
7 6
area)
+0 Resv Resv
+1 ERCLR Resv
+2 Resv Resv
+3 Resv Resv
+4
+5
+6
+7
+8
+9
+10
+11
FQ2-S/CH User's Manual
for Communications Settings
Setting
Yes (default)
No
&h8541
&h8542
&h8543
&h8544
Bits
5 4 3
Resv Resv Resv
Resv Resv Resv
Resv Resv Resv
Resv Resv Resv
Command code
Command parameter 1
Outputting Data and Controlling Operation through PROFINET
Description
Sets whether to output an NG string.
If [Yes] is selected, [Error string] setting for the Inspection
Item is outputted from the Sensor when scanning is fail.
[Inspection item] - [Modify] - [Output parameter] - [Error
string]
Description
2 1 0
Resv TRIG EXE Control flag 1 (8 bits)
Resv Resv Resv Control flag 2 (8 bits)
Resv Resv DSA Control flag 3 (8 bits)
Resv Resv Resv Control flag 4 (8 bits)
Command code (32 bits)
Command parameter 1 (32 bits)
157