Omron FQ2-S/CH Series User Manual page 437


Load Calibration Data
This command loads calibration data that is stored on the SD card inserted in the Touch Finder as the
calibration data with the specified number.
The source for calibration data is the following fixed directory on the SD card.
\Sensor name\CLB
Format
MRC SRC Sensor command code (4
(1 byte) (1 byte) bytes)
28 0F 0060A000
Response Format
MRC SRC MRES
(1 byte) (1 byte) (1 byte)
28 0F End code
End Codes
End code (hex)
0000 Command execution ended normally.
FFFF Command execution ended in an error.
Parameter Descriptions
Calibration number Specifies the calibration number you want to load. (0 to 31)
Calibration data file Specifies the calibration data file name you want to load.
name The file name extension (.clb) can be omitted.
Important
Do not turn off power to the Sensor until there is a response.
FQ2-S/CH User's Manual
for Communications Settings
Calibration
number
(4 bytes)
2 digits max.
SRES Sensor command code (4 bytes)
(1 byte)
0060A000
Description
Calibration data file name
(4 to 64 bytes)
64 characters max.
435
Command Control