Omron FQ2-S/CH Series User Manual page 235

Acquire System Data
This command acquires the value set for the specified system data.
Command (PLC to Sensor)
First word of
command
12 to 15
area
+2 0100
+3 0000
+4 0000
+5 0000
Response (Sensor to PLC)
First word of
response area
12 to 15
+2 0100
+3 0000
+4 0000
+5 0000
+6 0000
+7 0000
* System data numbers and details
For details about the items, refer to the setting descriptions for each item.
Except for the no-protocol (TCP) and no-protocol (UDP), get and set value is 1000 times the value.
System Type Item
data num-
ber
1 Configura- Startup scene
tion number
2 Configura- Startup scene
tion control
101 Camera Trigger delay
control
105 Measure- BUSY output
ment con- condition
trol
102 Logging Image data
control
FQ2-S/CH User's Manual
for Communications Settings
Bits
8 to 11 4 to 7
0000 0001
0000 0100
0000 0000
0000 0000
Bits
8 to 11 4 to 7
0000 0001
0000 0100
0000 0000
0000 0000
0000 0000
0000 0000
Data Range
size
4 0 to 7: For single-function models
0 to 31: For other models
4 0: Start with number when saved
1: Start with specified number
4 0 to 163,830
4 0: Measurement end
1: Data logging end
2: Image logging end
3: Until result display end
4 0: None
1: All
2: NG only
Description
0 to 3
0000
Command code
0000
0000
Command parameter number
0000
Description
0 to 3
0000 Command code
The command code for which the
0000
response applies is stored.
0000 Response code
Command execution result
0000
0: OK, FFFFFFFF: NG
0000 Acquired data
(1,000 times the value)
0000
Description
Specifies the scene num-
ber at startup.
Specifies whether to start
with the scene number
when data was saved or to
start with the specified
scene number.
Specifies the time (μs) to
shift when to capture the
image with a trigger delay.
This setting is applicable
for external trigger input
only.
Defines the interval to turn
on the BUSY signal when
performing measurements.
Specifies the logging con-
dition for measurement
image data.
*
233
Command Control