Omron FQ2-S/CH Series User Manual page 444


Save Image Data
Saves image data saved in the Sensor's memory by the logging function to the SD card inserted in the Touch
Finder as ifz data.
The destination for image data is the following fixed directory on the SD card.
\Sensor name\LOGIMAGE\Number*
* Number is a five digit number starting from 00000. The images are saved in increments of 100 images for each number, and when there
are over 100 images, the directory with the next number is created.
Format
MRC SRC
(1 byte) (1 byte)
28 0F
Response Format
MRC SRC
(1 byte) (1 byte)
28 0F
End Codes
End code (hex)
0000
FFFF
Parameter Descriptions
Image data number
Image data file name
Important
• If the same file is specified as an existing file, the existing file will be overwritten.
• Do not turn off power to the Sensor until there is a response.
442
Command Control
Sensor command code (4
bytes)
00704000
MRES SRES
(1 byte) (1 byte)
End code
Command execution ended normally.
Command execution ended in an error.
Specifies the number of the image data to be saved.
The maximum number of logged images is 20 (image data number: 0 to 19).
The image data number of the latest image is 0.
Specifies the image data file name when saving. (64 characters max.)
The file name extension (.ifz) can be omitted.
Image data file name
(4 to 64 bytes)
64 characters max.
Sensor command code
(4 bytes)
00704000
Description
FQ2-S/CH User's Manual
for Communications Settings