Omron FQ2-S/CH Series User Manual page 362

IMAGESAVE or IS
Saves image data saved in the Sensor's memory by the logging function to the SD card inserted in the Touch
Finder as ifz data.
The destination for image data is the following fixed directory on the SD card.
\Sensor name\LOGIMAGE\Number
* Number is a five digit number starting from 00000. The images are saved in increments of 100 images for each number,
and when there are over 100 images, the directory with the next number is created.
Note
Image data is stored to the following directory when you use TouchFinder for PC.
\My Documents\OMRON FQ\SDCard\Sensor name\LOGIMAGE\*
* The file is stored to the under the LOGIMAGE folder when you use TouchFinder for PC.
There is no limit to store the number of file.
<Command format>
I M A G E S A
or
I S
<Response format>
When Processing Is Performed Normally
When Processing Is Not Performed Normally
<Parameter Descriptions>
Image data number
Image data file name
Important
• If the specified file name already exists, this existing file will be overwritten.
• Do not turn off power to the Sensor until there is a response.
Note
Image data is stored to the following directory when you use TouchFinder for PC.
\My Documents\OMRON FQ\SDCard\Sensor name\LOGIMAGE\*
* The file is stored to the under the LOGIMAGE folder when you use TouchFinder for PC.
There is no limit to store the number of file.
360
Command Control
*
V E
C
R
Image data file name when saving
Image data number (2 digits max.)
Specifies the number of the image data to be saved.
The maximum number of logged images is 20 (image data number: 0 to 19).
The image data number of the latest image is 0.
Specifies the image data file name when saving. (64 characters max.)
The file name extension (.ifz) can be omitted.
C
R
Image data file name when saving
Image data number (2 digits max.)
FQ2-S/CH User's Manual
for Communications Settings