Omron FQ2-S/CH Series User Manual page 431


Set System Data
Sets the value to the specified system data.
System data numbers and details: p. 233
Note
All output signals are turned OFF after command is executed.
All output signals except RUN signal are turned OFF when Sensor Data Unit is connected.
Command Format
MRC SRC Sensor command code (4
(1 byte) (1 byte) bytes)
28 0F 00504010
Response Format
MRC SRC MRES
(1 byte) (1 byte) (1 byte)
28 0F End code
End Codes
End code (hex)
0000 Command execution ended normally.
FFFF Command execution ended in an error.
Parameter Descriptions
System data number* Specifies the number that corresponds to the system data to be set.
Setting value Specifies the setting value to be set to the system data.
FQ2-S/CH User's Manual
for Communications Settings
System data number (4 bytes)
3 digits max.
SRES Sensor command code (4 bytes)
(1 byte)
00504010
Description
Setting value
(4 bytes)
Dependent on the
system data
(1,000 times the
actual value)
Command Control
429