Omron FQ2-S/CH Series User Manual page 213

Function
Changes the range set as the measurement region or
the model registration region for an inspection item.
Changes the range set as the measurement region or
the model registration region for an image adjustment
item (filter item/position compensation item).
Sets the specified dictionary data cutout region parame-
ters.
Sets the value to the specified system data.
Sets the value of the terminal offset data that is added
to the IN0 to IN4 command parameters
Sets the input status (allowed/prohibited) of the commu-
nications port for the specified communications proto-
col.
Sets the output status (allowed/prohibited) of the com-
munications port for the specified communications pro-
tocol.
Sets the output signal ON/OFF status for the specified
parallel I/O terminal.
Batch sets the ON/OFF status for the all parallel I/O out-
put terminals other than the D terminals (D0 to D15).
Batch sets the ON/OFF status for the D terminals (D0 to
D15).
Sets the FQ2 execution status (execution mode).
Set the current date and time information.
File Load Commands
Function
Loads scene data that is stored on the SD card inserted
in the Touch Finder.
Loads all scene data that is stored on the SD card
inserted in the Touch Finder.
Loads system data that is stored on the SD card
inserted in the Touch Finder.
Loads all setting data (all scene data, system data, cali-
bration group data) for the Sensor saved as a backup
file from the SD card inserted in the Touch Finder.
Loads calibration data that is stored on the SD card
inserted in the Touch Finder as the specified calibration
number.
Loads all calibration data that is stored on the SD card
inserted in the Touch Finder.
FQ2-S/CH User's Manual
for Communications Settings
OK: Applicable command, RST: Command with restricted execution, NA: Non-applicable command
Parallel
p. 46, p. 75
NA
NA
NA
NA
NA
NA
NA
NA
NA
NA
NA
NA
OK: Applicable command, RST: Command with restricted execution, NA: Non-applicable command
Parallel
p. 46, p. 75
NA
NA
NA
NA
NA
NA
PLC link EtherNet/ PROFINET
p. 138 IP p. 164
(Tag Data
Links)
p. 112
NA NA NA
NA NA NA
NA NA NA
OK OK OK
OK OK OK
OK OK OK
OK OK OK
OK OK OK
OK OK OK
OK OK OK
OK OK OK
OK OK OK
PLC link EtherNet/ PROFINET
p. 139 IP p. 165
(Tag Data
Links)
p. 113
OK OK OK
OK OK OK
OK OK OK
OK OK OK
OK OK OK
OK OK OK
No-proto- No-proto-
col (TCP/ col (FINS)
UDP/RS- p. 198
232C)
p. 185
OK NA
OK NA
OK NA
OK OK
OK OK
OK OK
OK OK
OK OK
OK OK
OK OK
OK OK
OK OK
No-protocol No-proto-
(TCP/UDP/ col (FINS)
RS-232C) p. 198
p. 186,
p. 190
OK OK
OK OK
OK OK
OK OK
OK OK
OK OK
211
Command Control