Omron FQ2-S/CH Series User Manual page 181

Item
Digits of inte-
ger
Digits of dec-
imal
Negative
0 Sup-
pressed
For ASCII
Field separa-
tor
Record sep-
arator
For Binary Decimal out-
put form
• When Output Format Is ASCII
Set the parameters for integer digits, decimal digits, negative numbers, 0 suppression, the field separator, and
the record separator.
• Output Format
Measured value of
data 0
Note
The data output method, digits, and data separators can be changed as needed.
Example: Integer digits: 5, decimal digits: 3, negative number expression: −, zero suppressed: none, field
separator: comma, record separator: CR
1 2 3 4 5 . 6 7 8 ,
Measured value of data 0
Field separator
*1 Because the record separator is set to CR, only one record is output for each measurement. A blank line (CR: delimiter) will therefore be
entered after the record separator. If you do not want a blank line, set the record separator to None.
Note
The field separator is not output unless the data continues.
The following range of values can be output.
−999,999,999.9999 ≤ Measured value ≤ 999,999,999.9999
If the measured value is lower than −999,999,999.9999, then −999,999,999.9999 is output.
If the measured value is higher than 999,999,999.9999, then 999,999,999.9999 is output.
The following values are output if JG (Judge) is set.
OK: 0
NG: −1
FQ2-S/CH User's Manual
for Communications Settings
Description
Sets the number of digits in the integer part of
the number.
Set the number of digits in the integer part.
Sets the way to express negative numbers.
Sets whether to use zero suppression.
Sets the field separator.
Sets the record separator.
Set the decimal output form for numerical data. Floating point or fixed point (default:
Measured value of
,
data 1
5 6 7 . 3 2 1 ,
Measured value Measured
of data 1 value of data 2
Field separator
Control and Output in No-Protocol (TCP) / No-Protocol (UDP)
1 to 10 digits
Default: 6 digits
0 to 4 digits
Default: 4 digits
− or 8
Default: −
Yes or No
Default: No
OFF, comma, tab, space, CR, LF, or
CR+LF
Default: OFF
OFF, comma, tab, space, CR, LF, or
CR+LF
Default: OFF
Fixed point)
Measured value of
, · · ·
data 7
7 6 . 9 2 1 , , 6 5
Field separator
Field separator
Setting range
CR
*1
9 8 7 . 1 6 5 CR CR
Measured
Delimiter
value of data 7
Record separator
179