Omron FQ2-S/CH Series User Manual page 128

Item
Data output period 2 to 5,000 ms
Connection mode
Output IP address
(only TCP client)
Output port No.
(only TCP client)
GATE signal ON
period
Important
• Set the Sensor measurement interval to be longer than the Measurement time + Data output period value.
• Changes to settings are not applied until the Sensor is restarted. Therefore, save the settings and then restart the
Sensor
Section 5 Testing and Saving Settings
in Sensor FQ2-S/CH Series User's Manual (Cat. No. Z337)
Section 7 Convenient Functions
in Sensor FQ2-S/CH Series User's Manual (Cat. No. Z337)
• When you select [TCP server] in [Connection mode], the output port number is fixed 9877.
126
Controlling Operation and Outputting Data with PLC Link Communications
Setting range
This function is enabled when [Output handshake] is set to [No].
You can set the period to output the measurement result.
(default: 40 ms)
Set [Data output period]
Be sure to set [Data output period] to be shorter than the measure-
ment interval.
TCP server
TCP client Sets the TCP connection mode.
Default: TCP server
a.b.c.d
a: 1 to 223
b: 0 to 255
Sets the IP address of the connected external device (PLC, etc.).
c: 0 to 255
d: 1 to 254
Default:10.5.5.111
0 to 65,535 Sets the port number used for data outputs.
Default: 9,600 Set the same port number as the port number set for the connected
external device.
This parameter is displayed and can be set only when [Output
handshake] is set to [No]. Set the period for outputting measure-
ment results.
2 to 5,000 ms
(default: 40 ms)
Set the Sensor measurement interval to be longer than the Mea-
surement time + Data output period value.
Description
Important
>
[Gate signal ON period].
Important
FQ2-S/CH User's Manual
for Communications Settings