Omron FQ2-S/CH Series User Manual page 328

DIOFFSET or DIO
Set Terminal Offset Data
This command sets the value of the terminal offset data that is added to the IN0 to IN4 command parameters
when executing parallel commands.
When using parallel command scene changing, you can change the scenes to change to by changing the Set
Terminal Offset Data value.
<Command Format>
Command
D I O F
or
D I O
Command Terminal offset value
Space
(0x20)
<Response Format>
When the Command Is Processed Normally
O K CR
Delimiter
When the Command Is Not Processed Normally
E R CR
Delimiter
<Parameter Descriptions>
Terminal offset value
326
Command Control
Terminal offset value
(4 digits max.)
F S E T
Space
(0x20)
CR
Delimiter
(4 digits max.)
Specifies the value to be added to the IN0 to IN4 command parameters when executing
parallel commands.
When using the Sensor in Expanded Mode while using the standard parallel interface of
the Sensor, the range of scene numbers that can be changed to with scene changing is
limited to 0 through 15. By offsetting the command parameter, the scene can be changed
to scene number 0 through 31.
CR
Delimiter
for Communications Settings
FQ2-S/CH User's Manual