Omron FQ2-S/CH Series User Manual page 418


Batch Set D Terminal Statuses
Batch sets the ON/OFF status for the D terminals (D0 to D15).
Important
Before executing this command, change the FQ2 execution mode to stop mode with the Set Execution Mode com-
mand.
Set Execution Mode: p.417
Command Format
MRC SRC
(1 byte) (1 byte)
28 0F
Response Format
MRC SRC
(1 byte) (1 byte)
28 0F
End Codes
End code (hex)
0000
FFFF
Parameter Descriptions
Terminal status
416
Command Control
Sensor command code (4
bytes)
00308030
MRES SRES
(1 byte) (1 byte)
End code
Command execution ended normally.
Command execution ended in an error.
Specifies the ON/OFF status for the terminal. (ON: 1, OFF: 0) (0 to 65,535)
BIT0: D0
BIT1: D1
BIT2: D2
BIT3: D3
BIT4: D4
BIT5: D5
BIT6: D6
BIT7: D7
BIT8: D8
BIT9: D9
BIT10: D10
BIT11: D11
BIT12: D12
BIT13: D13
BIT14: D14
BIT15: D15
Terminal status (4 bytes)
5 digits max.
Sensor command code (4 bytes)
00308030
Description
FQ2-S/CH User's Manual
for Communications Settings