9.10 Save And Load The Camera Setting Data; The Camera Settings Saving - Omron STC-SBS312POE Product Specifications And User's Manual

9.10 Save and load the camera setting data

The camera has the camera setting including the factory default, load function.
The camera has below two camera settings.
Default: The factory default data (This data cannot change)
UserSet1: Changeable data
These camera settings load to the register in the RAM on the camera.
The camera settings saving and loading is controllable with "UserSetSelector" and "UserSetDefaultSelector"
parameters, and "UserSetLoad" and "UserSetSave" commands in UserSetControl category of GenICam.
The details of the parameters and the functions are in the table below:
GenICam parameters
UserSetSelector
UserSetDefaultSelector
UserSetLoad
UserSetSave

The camera settings saving

RAM
register
Selector
UserSetSelector
The camera settings saving procedure
1. Selects "UserSet1" at UserSetSelector.
2. Executes UserSetSave.
STC-SBS312POE / STC-SCS312POE / STC-SBS500POE / STC-SCS500POE
Product Specifications and User's Guide
For more information please contact Aegis Electronic Group, Inc. *(888)687-6877 *aegis-g2@aegiselect.com *http://www.aegiselect.com
Enumeration Select "Default" or "UserSet1"
type UserSetLoad or UserSetSave process for the selected data.
Enumeration Select which settings ("Default or UserSet1") load automatically
type when the camera power is on.
Selection saves automatically.
Command type The camera settings load from ROM to the register in RAM.
Command type The camera settings at the register in RAM save to ROM.
ROM
UserSet1
ROM
Default
When UserSetSave is executing,
the camera settings in the register at
RAM, save to ROM that is selected
at UserSetSelector
Caution:
UserSetSave command is only
available when "UserSet1" is selected
at UserSetSelector
No.16S019-05
49/62