Motorola MPC823e Reference Manual page 561

You must initialize the parameter RAM values before the channel is enabled. However, they
must only be modified when there is no DMA activity.
• Buffer Address Pointer—The buffer address pointer (BAPR) contains 32 address bits
of the destination buffer address used by the IDMA. The BAPR must be programmed
to burst-aligned address. In progressive mode, the BAPR is incremented by 16 bytes
after each transfer and it is incremented by 16 for each burst. In interlaced mode the
BAPR is incremented by 16 for each burst while it is within a line and then it is
incremented by the raw bytes register to point to the next line.
• Byte Count Register—The 32-bit byte count register (BCR) specifies the number of
bytes to be transferred by the IDMA. The BCR is decremented by 16 bytes after each
transfer and must be programmed as a multiple of 16. In progressive mode, the IDMA
channel will terminate the transfer of a block of data if this register reaches zero during
operation.
• DMA Channel Mode Register—The 32-bit DMA channel mode register (DCMR)
controls the channel operation mode.
DCMR
BIT 0 1 2
FIELD
MB1 RESERVED
RESET
0 0
R/W
R/W R/W
ADDR
BIT 16 17 18
FIELD
RESET
R/W
ADDR
MB1—Must Be 1
For DMA operation, this bit must be set to 1.
Bits 1–2, 9 11, 16 31—Reserved
— —
These bits are reserved and must be set to 0.
MOTOROLA
3 4 5 6 7
BO AT STR
0 0
R/W R/W R/W
(IMMR & 0xFFFF0000) + 0x3CC8
19 20 21 22 23
RESERVED
0
R/W
(IMMR & 0xFFFF0000) + 0x3CCA
MPC823e REFERENCE MANUAL
Communication Processor Module
8 9 10 11 12
RESERVED EDGE ITLC
0 0 0
R/W R/W
24 25 26 27 28
13 14 15
BPR
0 0
R/W R/W
29 30 31
16-107