Fuel Cut Relay; Ect Sensor - Honda NC700XA Service Manual

dummyhead dummyhead
PGM-FI SYSTEM

FUEL CUT RELAY

INSPECTION
Remove the maintenance lid (page 21-6).
Open the fuse/relay box cover and remove the fuel cut
relay [1].
Connect a ohmmeter to the fuel cut relay [1] terminals.
Connect a 12 V battery to the fuel cut relay terminals as
shown.
There should be continuity only when 12 V battery is
connected.
If there is no continuity only when the 12 V battery is
connected, replace the fuel cut relay.

ECT SENSOR

REMOVAL/INSTALLATION
Drain the coolant (page 8-6).
Disconnect the ECT sensor 2P connector [1].
Remove the ECT
sensor while the
Remove the ECT sensor [2] and O-ring [3].
engine is cold.
Install a new O-ring onto the ECT sensor and install
them.
Tighten the ECT sensor to the specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Connect the ECT sensor 2P connector.
Fill the cooling system with recommended coolant
(page 8-6).
4-64
[1]
[1]
[1]
[2] [3]