Texas Instruments SimpleLink CC2620 Technical Reference Manual page 1302

AUX – Sensor Controller Registers
17.7.7.7 WUEVFLAGS Register (Offset = 28h) [reset = 0h]
WUEVFLAGS is shown in
Wake-up Event Flags
Status of wake-up events from the AON domain
The event flags are cleared by setting the corresponding bits in WUEVCLR
31 30
23 22
15 14
7 6
Bit Field
31-3 RESERVED
2 AON_RTC_CH2
1 AON_SW
0 AON_PROG_WU
1302
AUX – Sensor Controller with Digital and Analog Peripherals
Figure 17-68 and described in
Figure 17-68. WUEVFLAGS Register
29 28
RESERVED
R-0h
21 20
RESERVED
R-0h
13 12
RESERVED
R-0h
5 4
RESERVED
R-0h
Table 17-93. WUEVFLAGS Register Field Descriptions
Type Reset
R 0h
R 0h
R 0h
R 0h
Copyright © 2015, Texas Instruments Incorporated
Table 17-93.
27 26
19 18
11 10
3 2
AON_RTC_CH
2
R-0h
Description
Software must not rely on the value of a reserved. Writing any other
value than the reset value may result in undefined behavior.
Indicates pending event from AON_RTC_CH2 compare. Note that
this flag will be set whenever the AON_RTC_CH2 event happens,
but that does not mean that this event is a wake-up event. To make
the AON_RTC_CH2 a wake-up event for the AUX domain configure
it as a wake-up event in AON_EVENT:AUXWUSEL.WU0_EV,
AON_EVENT:AUXWUSEL.WU1_EV or
AON_EVENT:AUXWUSEL.WU2_EV.
Indicates pending event triggered by system CPU writing a 1 to
AON_WUC:AUXCTL.SWEV.
Indicates pending event triggered by the sources selected in
AON_EVENT:AUXWUSEL.WU0_EV,
AON_EVENT:AUXWUSEL.WU1_EV and
AON_EVENT:AUXWUSEL.WU2_EV.
SWCU117C – February 2015 – Revised September 2015
www.ti.com
25 24
17 16
9 8
1 0
AON_SW AON_PROG_
WU
R-0h R-0h
Submit Documentation Feedback