Texas Instruments SimpleLink CC2620 Technical Reference Manual page 1291

www.ti.com
17.7.6.4 T0TARGET Register (Offset = Ch) [reset = 0h]
T0TARGET is shown in
Timer 0 Target
Target counter value for timer 0
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10
RESERVED
Bit Field
31-16 RESERVED
15-0 VALUE
SWCU117C – February 2015 – Revised September 2015
Submit Documentation Feedback
Figure 17-59 and described in
Figure 17-59. T0TARGET Register
R-0h
Table 17-83. T0TARGET Register Field Descriptions
Type Reset
R 0h
R/W 0h
Copyright © 2015, Texas Instruments Incorporated
AUX – Sensor Controller Registers
Table 17-83.
9
VALUE
R/W-0h
Description
Software must not rely on the value of a reserved. Writing any other
value than the reset value may result in undefined behavior.
Timer 0 counts from 0 to VALUE. Then gives an event and restarts if
configured to do to so in the T0CFG.RELOAD setting. If VALUE is
changed while timer 0 is running so that the count becomes higher
than VALUE timer 0 will also restart if configured to do so.
If T0CFG.MODE=0,no prescaler is used, and VALUE equals 1, the
TIMER0_EV event line will be always set
AUX – Sensor Controller with Digital and Analog Peripherals
8 7 6 5 4 3 2 1 0
1291