Texas Instruments SimpleLink CC2620 Technical Reference Manual page 1580

Proprietary Radio
Byte Index Field Name
14 pktConf
15 rxConf
16–19 syncWord0
20–23 syncWord1
24–25 maxPktLen
26–27 hdrConf
28–29 addrConf
30 lenOffset
31 endTrigger
32–35 endTime
36–39 pAddr
40–43 pQueue
44–47 pOutput
1580
Radio
Table 23-138. CMD_PROP_RX_ADV Command Structure
Bits Bit Field Name
0 bFsOff
1 bRepeatOk
2 bRepeatNok
3 bUseCrc
4 bCrcIncSw
5 bCrcIncHdr
6 endType
7 filterOp
0–5 numHdrBits
6–10 lenPos
11–15 numLenBits
0 addrType
1–5 addrSize
6–10 addrPos
11–15 numAddr
Copyright © 2015, Texas Instruments Incorporated
Type Description
0: Keep frequency synthesizer on after
W command.
1: Turn frequency synthesizer off after command.
0: End operation after receiving a packet
correctly.
W
1: Go back to sync search after receiving a
packet correctly.
0: End operation after receiving a packet with
CRC error.
W
1: Go back to sync search after receiving a
packet with CRC error.
0: Do not check CRC.
W
1: Check CRC.
0: Do not include sync word in CRC calculation.
W
1: Include sync word in CRC calculation.
0: Do not include header in CRC calculation.
W
1: Include header in CRC calculation.
0: Packet is received to the end if end trigger
happens after sync is obtained.
W
1: Packet reception is stopped if end trigger
happens.
0: Stop receiver and restart sync search on
address mismatch.
W
1: Receive packet and mark it as ignored on
address mismatch.
RX configuration, refer to
W
details.
W Sync word to listen for
W Alternative sync word if nonzero
Maximum length of received packets
W
0: Unlimited or unknown length
W Number of bits in header (0–32)
W Position of length field in header (0–31)
W Number of bits in length field (0–16)
0: Address after header
W
1: Address in header
If addrType = 0: Address size in bytes. If
W
addrType = 1: Address size in bits.
If addrType = 1: Bit position of address in header
W If addrType = 0: nonzero to extend address with
sync word identifier
W Number of addresses in address list
W Signed value to add to length field
W Trigger classifier for ending the operation
W Time to end the operation
W Pointer to address list
W Pointer to receive queue
W Pointer to output structure
SWCU117C – February 2015 – Revised September 2015
www.ti.com
Table 23-144 for
Submit Documentation Feedback