Texas Instruments SimpleLink CC2620 Technical Reference Manual page 1274

AUX – Sensor Controller Registers
17.7.5.3 RESULT Register (Offset = 8h) [reset = 2h]
RESULT is shown in
Result
Result of last TDC conversion
31 30 29 28
RESERVED
R-0h
15 14 13 12
Bit Field
31-25 RESERVED
24-0 VALUE
1274
AUX – Sensor Controller with Digital and Analog Peripherals
Figure 17-48 and described in
Figure 17-48. RESULT Register
27 26 25 24
11 10 9 8
Table 17-71. RESULT Register Field Descriptions
Type Reset
R 0h
R 2h
Copyright © 2015, Texas Instruments Incorporated
Table 17-71.
23 22 21
VALUE
7 6 5
VALUE
R-2h
Description
Software must not rely on the value of a reserved. Writing any other
value than the reset value may result in undefined behavior.
Result of the TDC conversion. The result is in clock edges of the
clock selected in DDI_0_OSC:CTL0.ACLK_TDC_SRC_SEL. Both
rising and falling edges are counted.
When saturating the result is slightly higher than the saturation limit,
since it takes a non-zero time to stop the measurement. The highest
saturation limit is 24 bits (see SATCFG.LIMIT) so maximum value of
VALUE is hence slightly above 2
SWCU117C – February 2015 – Revised September 2015
www.ti.com
20 19 18 17
R-2h
4 3 2 1
24
.
Submit Documentation Feedback
16
0