Texas Instruments SimpleLink CC2620 Technical Reference Manual page 1240

AUX – Sensor Controller Registers
17.7.3.1 VECCFG0 Register (Offset = 0h) [reset = 0h]
VECCFG0 is shown in
Vector Configuration 0
AUX_SCE event vectors 0 and 1 configuration
31 30
23 22
15 14
RESERVED VEC1_POL
R-0h R/W-0h
7 6
RESERVED VEC0_POL
R-0h R/W-0h
Bit Field
31-15 RESERVED
14 VEC1_POL
13 VEC1_EN
1240
AUX – Sensor Controller with Digital and Analog Peripherals
Figure 17-21 and described in
Figure 17-21. VECCFG0 Register
29 28
RESERVED
R-0h
21 20
RESERVED
R-0h
13 12
VEC1_EN
R/W-0h
5 4
VEC0_EN
R/W-0h
Table 17-42. VECCFG0 Register Field Descriptions
Type Reset
R 0h
R/W 0h
R/W 0h
Copyright © 2015, Texas Instruments Incorporated
Table 17-42.
27 26
19 18
11 10
VEC1_EV
R/W-0h
3 2
VEC0_EV
R/W-0h
Description
Software must not rely on the value of a reserved. Writing any other
value than the reset value may result in undefined behavior.
Selects vector 1 trigger event polarity.
To manually trigger vector 1 execution, set VEC1_EV to a known
static value, and toggle VEC1_POL twice.
0h = Rising edge triggers execution.
1h = Falling edge triggers execution.
Enables (1) or disables (0) triggering of vector 1 execution.
When enabled, the edge selected by VEC1_POL on the event
selected by VEC1_EV will set VECFLAGS.VEC1, which in turn
triggers vector 1 execution.
Note: Lower vectors (0) have priority.
0h = Event detection is disabled
1h = An event selected by VEC1_EV with polarity from VEC1_POL
triggers a jump to vector 1 when AUX_SCE is in sleep
SWCU117C – February 2015 – Revised September 2015
www.ti.com
25 24
17 16
9 8
1 0
Submit Documentation Feedback