Texas Instruments SimpleLink CC2620 Technical Reference Manual page 1511

www.ti.com
23.3.4.16 CMD_SET_TX_POWER: Set Transmit Power
Command ID number: 0x0010
CMD_SET_TX_POWER is an immediate command that takes the parameters listed in
Byte Index Field Name
0–1 commandNo
2-3 txPower
On reception, the radio CPU sets the transmit power for use the next time transmission is started. If a
packet is being transmitted, the transmit power is not updated until transmission starts for the next packet.
Each time transmission of a packet begins, temperature compensation of the transmit power is done.
The radio CPU returns Done in CMDSTA when finished.
SWCU117C – February 2015 – Revised September 2015
Submit Documentation Feedback
Table 23-47. CMD_SET_TX_POWER Command Format
Bits Bit Field Name
Copyright © 2015, Texas Instruments Incorporated
Type Description
W The command ID number
Output power setting; use value from
W
SmartRF Studio.
RF Core HAL
Table 23-47.
1511
Radio