Texas Instruments SimpleLink CC2620 Technical Reference Manual page 1120

General-purpose Timer Registers
13.5.1.24 TBPS Register (Offset = 60h) [reset = 0h]
TBPS is shown in
Timer B Pre-scale Snap-shot
Based on the value in the register field TBMR.TBILD, this register is updated with the value from TBPR
register either on the next cycle or on the next timeout.
This register shows the current value of the Timer B pre-scaler in the 16-bit mode. Note: When the
alternate timer clock (TIMCLK) is enabled a read of a timer value will return the current count -1.
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10
RESERVED
Bit Field
31-16 RESERVED
15-0 PSS
1120
Timers
Figure 13-32 and described in
Figure 13-32. TBPS Register
R-0h
Table 13-31. TBPS Register Field Descriptions
Type Reset
R 0h
R 0h
Copyright © 2015, Texas Instruments Incorporated
Table 13-31.
9
Description
Software must not rely on the value of a reserved. Writing any other
value than the reset value may result in undefined behavior.
GPT Timer B Pre-scaler
SWCU117C – February 2015 – Revised September 2015
www.ti.com
8 7 6 5 4 3 2 1
PSS
R-0h
Submit Documentation Feedback
0